Centrifuge Parts

Get your oil up over 200 degrees F with these custom heaters for our centrifuges

-Efficient - heat only the oil you need

-Maximize cleaning power - remove water and particles with confidence

 

Learn More

This is an updated shaft seal which will prevent any leaking from the shaft into the motor. Learn More

Bolt-in Feed Cone for Raw Power Centrifuges (Basic and Extreme).  Boost your cleaning power!

-Better Clean - reduces turbulance and improves flow

Learn More

If you REALLY want to build your own centrifuge, this is the Bare Essentials:

Includes:

-Rotor

-Seal and clamp

-Parts list for centrifuge

Learn More

Viton Radial Shaft Seal CRWA1 - V- 5/8in Shaft Pressed in Learn More

Sealed Replacement Bearings for Raw Power Centrifuges Learn More

Trantorque-Clamp Bushing for 5/8" Shaft Size, for 1" Component Bore Learn More

Motor Custom 1/3hp, 3450rpm, 120V 1 Phase Fully Wired with Switch and Plug Learn More

Motor Custom 1/3hp, 6000rpm, 3 Phase Learn More

Raw Power Centrifuge without motor Requires 56C-Face Motor Learn More

GS1 0.5 HP AC DRIVE 230V 1 PH INPUT 3 PH OUT Learn More

GS1 0.5 HP AC DRIVE 120V 1 PH INPUT 3 PH OUT Learn More

1000W@120V Immersion heater with thermostat 7" deep Learn More

1000W@230V Immersion heater with thermostat 7" deep Learn More