Fresh Off The Design Table
I am off to spend the week in Nantucket with my fiancé and her family so I apologize in advance for not getting back to anyone. None the less, I thought that I would leave a little teaser of what I put together this week.
I have taken the concept well developed by the Simple Centrifuge boys and added my engineering expertise. The result will be an equivalent product for a much reduced cost. I am going for a target of $1500 complete. However, those that want to be in on the development/prototype stage will have a special price of about $1000. Let me know if you are interested in the development program ASAP! I suspect it will only be open until the end of July. More information available in the forum HERE .
Last announcement is that I can immediately provide the Centrifuge rotor for a delivered price of $400 including the trantorque bushing. (I see little value in the machined cap) Once again let me know via the form on this site.
Finally, feel free to add your comments to this and any article on this site.
Leon